Laboratory Furnace

Products » Laboratory Furnace

Technical Specification of
shell of the Furnace :

The Shell of the Furnace would be fabricated out of 1.2 mm thick Mild Steel Sheets reinforced with minimum 35 X 35 X 5 mm angles.

The Front of the Furnace would be Fabricated Out of 1.6 Mm Thich Mild Sheets. all Mild Steel Members Will Be Welded and or Bolted Together as per Our Standard Practice, Whenever Required to Construct a Strudy Structure.

Heating Chamber :

The Heating Chamber Will Be Made Out of Cast Refractory Muffle. The Muffle Will Be Cast with Special Grade Refractory Cement to Withstand Temperature Up to 1300 ⁰C.

Heating Elements:

Spiral Shaped, Helical Would Heating Element Will Be Made Out of Suitable Grade of Fe.cr.al. Heating Element Alloy Wire, Having Sufficient Cross Section and Designed to Operate of Safest Surface Watt Loading for Enhance Element Life.

Insulation :

The Heating Chamber would be insulated with various layers of cold and / or Heat Face Insulating Bricks Followed By Ceramic / Mineral Wool Insulating Material as per Out Standard Practice.

Controls :

The Furnace will be controlled with a Thermocouple Sensed Digital Temperature Controller and Air Brake Magnetic Contactor this Control Eqpts / Instruments Will Be Rpovided Just Below the Furnace Chamber.

General Features :

Silicon Carbide Heating Elements in Matched Sets

Ensure Better Temperature

Uniformity

Longer Element Life.

Elements can Be Mounted Horizontally or Vertically.

Hot Face Lining Made of Special Refractory Bricks Followed By High Density Ceramic Fibre Insulations of Different Grades.

Thyristorised Power Control.

Micro - Processor Based Pid Temperature Controller / Programmer with Thermocouple Through Rear / Roof of Heating Chambers.

ENQUIRY FORM
Contact Information * fields are mandatory
Contact Person *
Company Name
Address *
Country *
Email ID *
Phone Number *
Fax
Enquiry Details
Enquiry For *
Details *
Verification Code *

Laboratory Furnace

ENQUIRY FORM